If your car battery is dead, you’ll need to jumpstart it or replace the battery. To jumpstart a car, you’ll need jumper cables and another vehicle with a working battery. Once you have the supplies and another vehicle, park the two vehicles close together so that the jumper cables can reach both batteries.
- Locate the car battery
- It is usually located under the hood of the car, near the front
- Remove the battery from its location
- You will need a wrench to loosen the bolts that hold it in place
- Take the battery to a local auto parts store or automotive shop to have it tested
- They can tell you if it needs to be replaced or simply recharged
- If the battery needs to be recharged, you can do this at home with a special charger designed for car batteries
- Follow the instructions that come with the charger carefully so as not to damage the battery
- Once the battery is charged, reinstall it in your car and start enjoying your ride!
How to Fix a Car Battery, Don’t Change Your Battery Refurbish it for another 3 Years
How Do I Bring My Car Battery Back to Life?
Most car batteries will last between three and five years before they need to be replaced, but with the right care and maintenance, you can extend the life of your battery significantly. If you’re noticing that your car’s battery isn’t holding a charge as well as it used to, there are a few things you can do to try and revive it.
First, check the connections on your battery terminals to make sure they’re clean and tight.
Corroded or loose terminals can prevent your battery from charging properly. If the connections look good, then next check the level of electrolyte fluid in each cell of the battery. The electrolyte should cover the lead plates inside each cell by about an inch (2.5 cm).
If it’s low, you can add distilled water to bring it up to level.
If those two things don’t solve the problem, then it’s likely that your battery is simply too old and needs to be replaced. However, if you catch the problem early enough, sometimes giving your battery a full day-long charge with a slow charger can help bring it back to life for a little while longer.
Can You Revive a Completely Dead Car Battery?
If your car battery is completely dead, it’s likely that you won’t be able to revive it and will need to replace it. However, if your battery is only partially discharged, you may be able to recharge it using a battery charger.
If you’re trying to recharge a dead battery, the first thing you’ll need to do is locate the positive and negative terminals.
Once you’ve found them, connect the positive terminal of the charger to the positive terminal of the battery, and then connect the negative terminal of the charger to the negative terminal of the battery.
Once the terminals are connected, turn on the charger and let it run until the indicator light shows that the battery is fully charged. Once it’s charged, try starting your car – if it starts, then you’re good to go!
If not, then unfortunately your battery may be too far gone and will need to be replaced.
How Do You Recondition a Dead Battery?
A dead battery is one that has lost its ability to hold a charge. The lead-acid batteries used in cars and trucks have a limited number of charging cycles and will eventually die. If you find yourself with a dead battery, there are steps you can take to recondition it.
Before you begin, make sure you have the proper safety gear. Lead-acid batteries release hydrogen gas when they’re being charged, so it’s important to wear gloves and eye protection. You’ll also need some distilled water and baking soda.
Start by removing the battery from the car or truck. Clean the terminals with a wire brush to remove any corrosion. Next, use a hydrometer to test the specific gravity of each cell.
If any of the cells read below 1.265, then that cell is considered dead and needs to be replaced.
If all of the cells are above 1.265, then you can begin reconditioning the battery. Start by mixing equal parts distilled water and baking soda together and pour it into each cell until it’s about half full.
Be careful not to overfill as this can damage the battery cells.
Next, attach jumper cables from a working battery to your dead one and let it charge for about 15 minutes before disconnecting everything again. Finally, fill each cell up with distilled water again and put the battery back in your car or truck.
.
How Does Epsom Salt Restore a Battery?
Epsom salt is often used as a home remedy to restore a battery. The theory behind using Epsom salt is that the sulfate in the salt will help to break down the lead oxide on the battery’s positive and negative terminals, allowing for better conductivity and restoring the battery’s charge.
To use Epsom salt to restore a battery, add one tablespoon of salt to two cups of warm water and stir until dissolved.
Use a clean cloth or sponge to apply the solution to the terminals, being careful not to get any water inside the battery case. Allow the solution to sit on the terminals for about 15 minutes before wiping it off and rinsing with clean water.

Credit: www.jdpower.com
Rejuvenate Car Battery With Vinegar
We all know that vinegar is a household staple with a million and one uses, but did you know that it can also be used to rejuvenate a car battery? That’s right – vinegar can help to bring an old battery back to life!
Here’s how it works: the acid in vinegar helps to clean the terminals of your battery, which can get corroded over time.
This corrosion can build up and prevent your battery from being able to properly conduct electricity, which will eventually lead to a dead battery. By cleaning the terminals with vinegar, you’re helping to ensure that your battery will be able to function properly for longer.
To rejuvenate your car battery with vinegar, simply remove the terminal covers and soak a cloth in undiluted white vinegar.
Wipe down the terminals and let them sit for about 15 minutes before rinsing with water and drying completely. You should do this every few months or so to help keep your battery in tip-top shape.
Conclusion
If your car battery dies, it can be a pain to get it started again. But with a little know-how, you can easily restore a car battery. All you need is some distilled water and baking soda.
First, remove the battery from your car. Then, using a funnel, pour distilled water into the battery until it reaches the top of the lead plates. Next, add baking soda to the water until it dissolves completely.
Finally, put the battery back in your car and start her up!